LS Shot Blast System (Used)

LS Shot Blast System (Used)

orCall (734) 854-8700


Equipment Specifications: Airless steel shot blasting system with opening size 72" wide x 12" tall 3/8" manganese wear plate liners in direct shot blast pattern in blast cabinet Four (4) LS TurboShot impeller wheels. 2 upper & 2 lower LS TurboShot impellers Each LS TurboShot wheel has eight blades LS TurboShot impeller wheel lined with replaceable wear plates Heavy duty 2" spherical four bolt flange bearings on the LS TurboShot impellers Abrasive feed system including augers, collection hopper, bucket elevator and air wash. Elevator: 10 gauge steel construction, 7.5 HP with 8" x 5" buckets. Multiple ply elevator belt Shot containment vestibules constructed from 10-gauge steel Vee tray and auger extends from the entrance, exit, lower and upper cross augers to return abrasive. Maintenance door to allow operator access to the interior of the blaster. Maintenance and inspection panel on augers and elevator Electrical box located on blast cabinet Single point electrical connection NEMA 12 electrical enclosure Amp meter to monitor abrasive load on each LS TurboShot impeller wheel Model DCC-20 reverse jet air pulse cartridge collector (ducting not included) 6,000 CFM. 8 replaceable cartridges 2,480 sq ft filter material 15-20 CFM @ 100-125 PSI required to operate dust collector pulse


Stock NumberVX-23010
Main blast cabinet construction1/4" manganese
Ls turboshot wheel motors20 HP each
Shot blow off40 HP includes shot removal plow
Entrance augers1 ea @ 1 HP,
Lower cross auger3 HP
Exit return augers1 ea @ 2 HP
Upper cross augerN/A
Power440 volt 3 phase power 60 cycle. Approximately 204-amp draw.
Cutler-hammer high voltage componentsUL registered components
Blaster opening size72" wide x 12" tall